Zirconia Tooth

Thanks to the Zirconia infrastructures produced with 3D cad-cam systems full zirconium, which is a completely biocompatible material, gingival compatibility is excellent and Zirconia edges that go under the gingiva pretty thin and polished. Thus, plaque accumulation does not occur and gum health is durably preserved.

Zirconia teeth are metal free, so they could be used both on anterior and posterior group teeth. They are compatible with all hard and soft tissues in the mouth. An allergic reaction does not occur.

During the treatment, a local anaesthesia is administered so that no pain is felt. Temporary teeth will be fitted after the procedure, during patient presence at the dentist unit. Thanks to these temporary teeth, with as same colour as your teeth, no pain is felt. Although there is slight tingling between sessions due to extreme sensitivity in very few patients, this situation disappears with the end of the treatment.

Zirconia teeth do not cause any taste change in the mouth. Thanks to the biocompatibility of the materials used, both taste changes and dental plaque build-up are prevented. Because it is not comprised of metal, it does not cause any taste change or oral malodour.

Zirconia teeth surface is completely smooth and polished, so it does not allow any plaque accumulation and does not change colour.

Because the crowns are clipped, you will not feel any discomfort. Zirconium does not cause tissue loss on your teeth.

The tooth, which will receive this crown, is roughened with a special dental acid, which scratches the surface and increases the bond between crown and tooth. Measurements taken are transferred to the virtual environment with intraoral scanners and the virtual design of the crown is performed. Your zirconium teeth are prepared in three-dimensional scrapers. With rehearsal, you control the colour, shape and pattern in your own mouth, and the designs are repeated according to your wishes. Then the crown is fitted onto your tooth. The dentist will check its appearance and fit before cementing it into position. Finally, it is then given a final polish.

For zirconium aesthetic veneer teeth, the loss of material on your teeth is less compared to laminated applications, also less than metal-based porcelain veneers. Your average tooth is grinded 1.5 mm from each edge.

Following your teeth cut, measurement is taken and temporary teeth are prepared at Izmir zirconium aesthetic dental centre special DentaPoint laboratory centre before you get up from the dentist's chair. One of the measurements taken is used for the zirconium, while the other one is used for your temporary aesthetic preview. Even if you only use your temporary teeth for 4 days, your temporary ones prepared in 3D scrapers are very aesthetic. All zirconium will be prepared according to your wishes.

While treating aesthetic teeth at DentaPoint, all chewing habits of the patient are determined beforehand. Especially in patients with teeth clenching problems, while preparing zirconia, the teeth that are effective in back group chewing are prepared over monolith (pure zirconium) basis so that no fracture occurs. Since the expansion coefficient of zirconium is the same as a natural tooth, there will be no subject to wear and fall under heat.

First, your type of gum disease must be diagnosed. After the diagnosis, necessary treatments are carried and your gum health is restored, then aesthetic zirconia teeth are applied.